• An adequate power source is within 6 feet (1.83 meters) of the switch.
One 15-amp circuit is required for each power supply.
• At least 2 inches (5.08 centimeters) of clearance on the front and back
of the switch for ventilation.
• Cables should be dressed to prevent blocking air flow.
Package contents
The following describes the components that are provided with each switch. If any components are
missing, contact the switch vendor.
1. VSP 7200 Series (either a VSP 7254XSQ or VSP 7254XTQ).
2. Rack-mounting hardware that includes:
• Rack-mount brackets
• Screws to attach brackets to the switch
• Screws to secure the switch to the equipment rack
3. The VSP 7200 Series supports two field-replaceable power supplies (either front-to-back or
back-to-front). One power supply ships with the unit.
4. Three field-replaceable fan modules (either front-to-back or back-to-front)
5. Documentation
Note:
A 300mm-900mm slide rack mounting kit is available as an option.
Power cords must be ordered separately. Ensure you order the correct power cord for your
region. For more information, see
Power cord types and order codes
on page 14.
Installing a power supply
The VSP 7200 Series ship with a power supply, but it is not installed in the chassis. Refer to the
following procedures to install either an AC or a DC power supply.
There are two power supply slots (PSU1 on the left side and PSU2 on the right).
• If you only have one power supply, you can install it in either PSU1 or PSU2.
• If you install a second power supply, neither one acts as a primary power supply. The two
power supplies load share equally.
Package contents
March 2020
Installing the VSP 7200 Series
23
