Extreme Networks e" series, Руководство по установке оборудования

Страница: 96 / 394

96 Extreme Networks Consolidated "e" and "i" Series Hardware Installation Guide
Summit Switch Models
LEDs
Each Summit7i model has the following LEDs:
• Unit status
• Management
• Port status
• Port speed
• Management port
For information about the LEDs and their activity on the Summit7i switch, see “Summit1i, Summit5i,
Summit7i, and Summit48i Switch LEDs” on page 97.
GBIC Ports
Both Summit7i switch models provide four unpopulated GBIC ports with SC connectors. You can use
the following GBICs in the Summit7i switch:
• 1000BASE-SX
• 1000BASE-LX
• 1000BASE-LX70
• ZX GBIC
• LX100
• UTP GBIC
For more information about the supported GBIC types, see “GBIC Type and Hardware/Software
Support” on page 23. For specifications of individual GBIC models, see “GBIC Specifications” on
page 340.
Reset Button
Use the reset button to cycle the switch down and bring the switch back up without powering off the
switch. Your saved switch configuration information is not lost; unsaved switch configurations are lost.
Use a non-conductive tool to push the reset button.
Console Port
Use the console port (9-pin, “D” type connector) for local management. This port allows you to attach a
terminal and access the CLI through a serial connection.
Modem Port
Use the modem port to connect a modem for remote access to the command line interface (CLI).
Ethernet Management Port
Use the management port (10/100 Mbps Ethernet, RJ-45 connector) to plug an Ethernet cable directly
from your laptop into the switch for out-of-band management. This provides you with direct access into
the switch and allows you to view and locally manage the switch configurations.