Extreme Flight slick 580 exp, Руководство по сборке

Страница: 7 / 14

Locate one of the small ball-link ends, and using CA
glue, install it into the hole you drilled in the rudder,
as shown. This will be the guide for the tiller-wire
which steers the tail wheel.
Using three wood screws, install the tail wheel as
shown. The tail wheel axle of swing should be in line
with the rudder hinges. As you install each screw,
screw it in half-way, then remove it and add a drop
of CA glue to the hole, then screw the screw all the
way in.
Install the two tail-wheel collars and the tail wheel
as shown. Use Loctite on the set screws of the col-
lars.
The rudder horn is double-sided. Use sandpaper or
an emery board to scuff the middle part which will
lgue into the rudder. Assemble one side with ball link
as you did the elevator horn. Place part-way into the
rudder and shown
Apply epoxy glue to the rudder horn where it will be
inside the slot in the rudder. Press the horn into the
rudder until it is centered. Assemble the ball link and
screw on the opposite side, make certain the horn
assmbly is centered, and add the square horn plates
with epoxy as shown. Clean up any excess epoxy
with alcohol and allow to cure.
8
Locate the elevator pushrod, and remove the balllink
from the elevator horn. To assemble the elevator
pushrod, you will need to screw the ball links onto
the elevator pushrod. We prefer to use a cordless
drill. Chuck the bare pushrod in and hold the first
ball link, and screw in as shown. Then, we turn the
shaft around, and chuck the ball link into the drill
to install the second ball link. NOTE: both ends of
the elevator pushod are conventional “right hand”
threads.
Install the servo arm and pushrod. We recommend
Extreme Flight RC aluminum servo arms. Pictured is
a 1.5” arm, but we recommend a 2.0” arm for max-
imum options in control throw. Install the pushrod
with 3mm hanrdware, note that you must use either
a nyloc nut or loctite on the screw which attaches
the ball link to the servo arm.