www.modellmarkt24.ch
3
Tips for Success:
1. Before starting assembly, take a few minutes to read the entire instruction manual to
familiarize yourself with the assembly process.
2. Please take a few minutes and go over all the seams on the aircraft with a covering iron
on a medium heat setting.
3. Use a fresh bottle of thin CA with a fine glue tip when attaching the CA hinges. This
will ensure that the proper amount of CA wicks into the hinge and surrounding balsa
wood and creates a proper bond between the wood and hinges. We are big fans of the
Mercury line of adhesives as well as the glue tips provided by them.
4. Apply a couple drops of CA to high stress areas such as anti-rotation pins, landing gear
mounts, servo trays and motor box support mounts.
5. All of the G10 control horns are the same with the exception of the elevator horn. Its
base has been shortened to fit the depth of the elevator.
6. When applying decals, first clean the area where the decal will be applied with alcohol.
Mist the area lightly with Rapid Tac or Windex before applying the decal which will allow
you to properly position it, then use a rubber squeegee to push all of the liquid from under
the decal. This will result in very few air pockets trapped under the decal.
7. Take the time to properly balance and trim your aircraft and set up rates and
exponential values. Your flying experience will be greatly enhanced by doing this.
www.modellmarkt24.ch
