Extreme Flight RC EXTRA 300 EXP V2, Инструкция по сборке

Страница: 17 / 30

www.modellmarkt24.ch; www.modellmarkt24.de
17
13. Locate a 2mm ball link from the hardware bag. Drill a hole 2 inches back from the
leading edge of the rudder on the bottom of the rudder surface to accept the shank on the
ball link.
14. Scuff the shaft of the ball link with coarse sandpaper. Mix up a small amount of 5
minute epoxy and apply it to the ball link and the hole in the bottom of the rudder. Push
the ball link into the hole as shown in the picture. Use a little excess epoxy to form a fillet
around the bottom of the ball link. Make sure the hole in the brass ball is aligned front to
rear to accept the tailwheel tiller arm. Go ahead and glue the hinges into the rudder at this
time using the procedure outlined previously.
15. Position the tailwheel assembly on the rear bottom of the fuselage and be sure the
tailwheel wire is aligned with the rudder hinge line. Secure the tailwheel with a couple of
pieces of masking tape while
you drill 2 holes with a 1/16” drill bit. Apply a few drops of
thin CA to the holes and allow to dry then secure the assembly to the bottom of the
fuselage as shown with the 2 provided wood screws.
www.modellmarkt24.ch; www.modellmarkt24.de