23
Trim the excess around the
turbocharger exhaust details with a
knife or scissors. Sand the edges to
clean them up so they can sit flush
to the fuselage.
Note:
it is easiest to treat as two
separate pieces as shown in these
manual photos.
Position the turbo exhaust and
mark position lightly with sharp
pencil (pencil, as any marks left
visible will look like nifty scale
details).
Apply plastic compatible adhesive
to the inside of the marked area.
Be careful not to place glue outside
the area.
Apply thick bead of glue to the
inside of the turbo exhaust piece.
Large bead of glue is helpful to
ensure it sticks, but still be cautious
that it will not run out from under
the piece when placed on the
model.
