17
ENGLISH
Battery type and replacement
To insert/replace the batteries, simply remove the battery
protection cover at the back of the handheld device (figure 1).
Insert the batteries in accordance with the symbols featured on the
handheld device and on the battery itself.
3 AAA batteries are required for the remote control to function.
cOnFIGUratIOn
LCD hAnDheLD remoTe CoDIng proCeDure:
1. Disconnect the power supply to the stove.
2. press the keys
OK
and
OK
at the same time until the
UNIT
selection screen appears.
3. using keys
OK
and
OK
select the new
UNIT
'.
4. power the stove. Within 10 seconds (the LeD on the emergency module will flash) confirm the selected unit by pressing
OK
on the
handheld control.
5. The LeD on the emergency module will remain on for 5 seconds to confirm the new configuration.
6. If the configuration was unsuccessful, the display will read "
DEVICE NOT FOUND
". In this case, repeat the procedure.
J
the handheld cOntrOl Is already cOnFIGUred wIth "UnIt 0". IF there Is anOther stOVe, tO aVOId
InterFerences, a new cOnFIGUratIOn mUst Be perFOrmed, mOdIFyInG One OF the twO stOVes.
sOme radIO FreqUency applIances (e.G. mOBIle phOnes, etc...) may caUse InterFerence wIth
cOmmUnIcatIOn Between the handheld deVIce and the stOVe.
Respect the environment!
used batteries contain metals that are harmful to the environment, and therefore must be disposed of separately in
special containers.
handheld remOte
(figure 1)
handheld remOte rOOm prOBe
calIBratIOn
This mode allows for the calibration of the room temperature
detected by the handheld remote (with ventilation active only).
For correct calibration, it is recommended to position the LCD
handheld remote in a room with constant temperature and wait
for at least two hours.
Below find the calibration procedure:
Access the menu and reach “
TECH MENU
”.
Set the access key "F4". - "
ADJ REMOTE PROBE
"
using the keys
OK
or
OK
adjust the desired ambient
calibration.
Save and exit with the key
OK
.
