8
SDL300-EN-V1.3 -10/11
Set the Beeper Sound ON or OFF
1.
Access the
bEEP
parameter.
2.
Use the arrow keys to select ON (enable) or OFF (disable).
3.
Press ENTER to confirm setting.
4.
Press and hold the SET key for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
Numerical Setting (comma or decimal)
European and USA numerical formats differ. The meter defaults to USA mode where a decimal
point is used to separate units from tenths, i.e.
20.00
; European formats use a comma, i.e.
20,00
to
separate units from tenths. To change this setting:
1.
Access the
dEC
parameter as described in the Accessing Setup Mode section above.
2.
Use the arrow keys to select USA or EUro.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET key for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
SD Card FORMATTING
1.
Access the
Sd-F
parameter.
2.
Use the arrow keys to select YES to format the card (select NO to abort). Note that all data on
the card will be lost if formatting is attempted.
3.
Press ENTER to confirm selection.
4.
Press ENTER again to re-confirm.
5.
The meter will automatically return to the normal operating mode when formatting is complete.
If not, press and hold the SET key for at least 1.5 seconds to exit to the normal operation
mode.
Set the Temperature Units of Measure (°C or °F)
1.
Access the
t-CF
parameter.
2.
Use the arrow keys to select °
C or
°
F
.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET key for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
Set the Temperature Thermocouple Type (J or K)
1.
Access the
tYPE
parameter.
2.
Use the arrow keys to select J or K.
3.
Press ENTER to confirm setting.
4.
Press and hold the SET key for at least 1.5 seconds to exit to the normal operation mode (or
simply wait 7 seconds for the meter to automatically switch to the normal operating mode).
