MO270-EU-EN-v2.1 11/12
11
MEMORY
The MEMORY menu allows for viewing data and naming/clearing data for up to 10 memory
groups. Refer to the dedicated ‘Memory Logging Mode’ section later in this guide.
ZERO MODE (Relative)
The ZERO function allows measurements to be displayed as the difference between the actual
reading and a stored reference reading. Follow the steps below:
1. From the normal measurement mode, take a moisture measurement that will represent the
reference value.
2. With the meter continuing to take this reading press the MENU (F1) soft-key, scroll to the
ZERO MODE field, and press the Enter key (the field color will change to blue indicating that
the ZERO function is active). The current measurement has now been zeroed.
3. Return to the normal measurement mode by pressing the EXIT soft-key. Now, all
subsequent readings will be displayed as on offset from the stored reference reading. For
example, if the reference is 20 and a measurement of 50 is taken, the meter will display 30
(50 actual reading minus 20 reference reading = 30 displayed reading).
Note
: The REL icon will flash on the measurement display screen while the ZERO function
is active.
4. To switch the ZERO function OFF, scroll to the ZERO MODE field again and press Enter
(the field color will change to gray indicating that the ZERO function is switched OFF).
Note
: The default state is ZERO MODE
OFF.
F2 - MODE
Repeated presses of the F2 MODE button allows scrolling through the three display modes:
Digital display, Graphical Trend Analysis display, and Analog display. The digital display includes
a bargraph at the bottom of the display. Note that the bargraph is color-coded where the alarm
region is shown in red and the acceptable region in green. For more on the Trend Analysis
display refer to the Trend Analysis section later in this guide.
TREND DIGITAL ANALOG
F3
– HOLD/SAVE
The HOLD menu freezes the displayed reading. When HOLD is pressed, two sub-menus SAVE
and EXIT appear. Press EXIT to un-freeze the display and return the meter to the normal
operating mode. Press SAVE to store the data to memory.
