382095 V4.1 7/06
25
WARNING: Select 50 or 60 Hz for transient capture. If AUTO is selected for frequency, the unit will not
allow entrance to the TRANSIENT capture mode (an audible beep will sound).
Down Load Transient Data
When the TRANSIENT button is pressed to display CAPTURED EVENTS, the data is also output through
the RS-232 interface simultaneously.
The data output is in the same format as the LCD display format (ASCII)
YEAR MONTH DAY HOUR MINUTE SECOND CT REF CODE
01 ELAPSED_TIME CYCLES CODE
02 ELAPSED_TIME CYCLES CODE
03 ELAPSED_TIME CYCLES CODE
04 ELAPSED_TIME CYCLES CODE
Datalogging Power Data (3P4W, 3P3W, 1P2W, 1P3W)
1. Set the datalogger sampling time (rate)
2. Press the POWER button to enter the power measurement mode.
3. Press
the
1
Φ
3
Φ
button to select the appropriate system (3P4W, 3P3W, 1P3W, or 1P2W).
4. Press the REC button to start logging. A
REC
symbol will display.
5. To stop logging, press the REC button again.
NOTE: To download data, send a CTRL+D command to the analyzer through RS-232C interface.
WARNING: The sampling time could be longer than the set value if there is no input at V1.
Down Load Power Data
1. Press the SETUP button.
2. “Down Load File” will be shown in reverse video.
3. Press
the
▲
or
▼
button to select the file number.
4. If the data stored in a selected file is power data, a leading symbol “P” will precede the file name
5. Press the EXIT button.
6. When a CTRL D command is received through the RS-232C port, it downloads stored power data.
NOTE: In the setup mode, the unit will not accept commands through the RS-232C port. To down load
data, press the EXIT button to return to normal measurement mode.
