8
the thaw water runs down the thaw water runoff channel to the tray on top of the compressor, where
it evaporates.
REGULARLY CLEAN THE APPLIANCE.
Remember that before cleaning the appliance and appliance body you must
disconnect the appliance from the electrical energy supply socket by pulling the
plug out of the electricity outlet.
•
Clean the appliance inner surfaces with warm soapy water. Dishwashing detergent may also be
used. Wipe dry inner and outer surfaces.
•
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
At least once a year clean dust away from the back part of the appliance body
and the compressor. A soft brush, electrostatic cloth or vacuum cleaner may be
used for cleaning.
•
REGULARLY CLEAN THE THAW WATER CHANNEL SPACE WITH A SPECIAL
CLEANER FOR THAT PURPOSE.
•
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for
cleaning the appliance inner and outer surfaces. DO NOT use for cleaning cloths
or sponges that have coarse surfaces intended for scrubbing.
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a helper.
You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors YOU CAN NOT lay the refrigerator horizontally!
Before you get started, please note the following:
∙
Always ensure that the correct number of washers are used on the hinge bolts.
∙
To ensure that the door can close tightly against the frame, take the utmost care that it is properly
aligned during reassembly.
Do the actions below in the order they are listed (see fig. 6, page 2):
W A R N I N G !
Turn off the freezer and pull the plug out of the electricity supply outlet.
1. Remove covers
c
from the inside of the housing and door and the upper bracket
6
together with
the nut and washers and the gasket under the bracket.
2. Remove the freezer door
1
. Remove the stop plate from the bottom
2
. Screw the stop plate
(included in the package) on the opposite side of the door to open the door to the left.
3. Remove the bottom cover
3
together with the small cover
4
.
4. Unscrew the shaft
5
together with the washers on the shaft and the catch
8
from the lower bracket
6
and screw them to the bracket
7
on the other side of the cabinet symmetrically to the former
position.
5. Push the freezer door onto the bracket
7
on the newly installed shaft
5
.
6. Remove the screw caps a and the blinds
b
. Unscrew the
9
fixing screws of the handle and screw
the handle on the opposite side of the door. Press the blinds into the remaining holes in the door and
place the covers on the screws.
7. Rotate the bracket
6
together with the washers on the shaft and the plastic gasket at an angle of
180 °. Unscrew the shaft together with the washers and screw in on the opposite side of the bracket.
After inserting the axis
6
of the bracket into the door of the refrigerator compartment, screw it on the
opposite side of the refrigerator in the lower holes. Cover
c
with the bracket and the remaining empty
cavity.
8. Insert the cover
4
into the guides on the opposite side of the bottom cover
3
. Replace the bottom
cover
3
in its original position.
Operation problems and their solutions.
What if …
•
The appliance is plugged in to the mains but it does not work and the electricity supply
voltage indicator is not illuminated.
Check that your house electricity supply installations are in
order. Check that the plug is correctly inserted into the electricity supply socket.
