Express Water EZRO5, Руководство по установке

Страница: 7 / 11

12 13
Tubing Quick Connect Guide
To Cut Tubing
M ake your cuts against a flat cutting surface with a razor blade, or use a handheld tube cutter. Any cuts to
your Tubing must be perfectly straight.
NOTE!
Improperly cut Tubing may leak water or fail to lock into Fittings.
Wait until all elements of your RO System are in their final locations before cutting your Tubing.
Make sure you measure the length you will need before cutting.
Attach Tubing
Push Tubing in straight and level with the
Collet. The Tubing will go 5/8ths of an inch
into the Collet before the lock is activated.
Pull out on the Tube to make sure the lock
has activated and the Tubing is secure.
NOTE! Once connected, make sure to
check tubing is secure.
5/8”
5/8”
Insert or Remove Locking Clips
To lock a Tube in place make sure the
Tubing is fully inserted then slide the open
end of the Clip between the Collet and
Fitting. The Clip must be removed before
the Tubing can be removed. To remove
the Clip pull away until it slides out from
between the Collet and Fitting. Unlocked Locked
The tubing in your RO System uses a Quick Connect locking mechanism to
lock the Color Coded Tubing in place. Be careful not to damage your tubing
as you unpack it.
NOTE!
Make sure to remove any plugs before attempting to insert tubing.
Plug
Collet
Locking
Clip
Fitting
Release Tubing/Plugs
If there is a Locking Clip on the Collet it must
be removed before the Tubing can be released.
Push and hold the Collet in to release the lock
while pulling out on the Tube/Plugs.
NOTE! Collet must be held down while
pulling up on the tube to release the tube.
Hold
Down
Pull
Up
Installation
1. Identify if your faucet is compatible with the 13/16”
female threaded diverter valve
- I f it is not compatible you may need the 13/16”
male to 13/16” male adapter -or the- 15/16” male to 13/16”
male adapter
- I f your faucet is not compatible with either of these
adapters you will need to purchase an appropriate adapter
to connect your faucet to the diverter valve
1. Push the RO Faucet stem into the Faucet Adapter on the
Post Activated Carbon Filter
2. Make sure the faucet is fully pushed in
CAUTION!
The water supply to the unit MUST be COLD WATER ONLY . Using HOT WATER will severely damage
your RO System.
2. Screw on Diverter Valve
(with appropriate adapters
if needed)
3. Remove the black
plug from the Union
Connection and insert the
Black Tubing
4. Remove the blue
plug from the Sediment
Filter and insert the
White Tubing
5. Check to make sure
tubes are fully inserted
15/16” to 13/16” 13/16” to 13/16”
Diverter Valve
RO Faucet