Express Water EZRO5, Руководство по установке

Страница: 3 / 11

READ THIS FIRST
Please pay attention to the following installation and safety recommendations:
- Read the installation manual before installing this system.
NOTE!
P lease make sure your installation location has enough room for the RO Countertop System. We suggest
an installation location where the RO Faucet can overhang your sink.
Incoming Water
Incoming water pressure must be between 45 PSI and 80 PSI. If your water pressure is under 45 PSI you
will need a booster pump on your system. If your water pressure is above 80 PSI you will need a pressure
regulator on your system. Test your water occasionally to make sure the system is performing. If your water is
microbiologically unsafe or of unknown quality do not use this system without adequate disinfection before
or after the system. Extremely hot or cold incoming water will damage the system and cannot be used.
Leaks
Inspect all connections after the installation to make sure no leaks occur, wait until after the system is
pressurized to inspect again. Check system occasionally after installation or maintenance to make sure no
leaks have developed.
General
This RO System unit is for climate controlled indoor use only. Exposure to overly high or low temperature
ranges will damage the unit. Follow all of your state and local laws and codes regarding plumbing even if
they differ from what is stated in this manual. If your state law requires use a professional licensed installer or
plumber who meets the requirements of this system. All o-rings, fittings, filter canisters, and teflon tape wears
out after a certain period of time. The lifetime of your components are subject to change with the quality of
the water supplied. Do not handle an unwrapped filter directly with your bare hands as this can cause early
filter failure. Use appropriate eye protection if you are performing any drilling.
Maintenance
The owner/user is obligated to properly maintain the RO System when necessary, at least once a year.
This includes the following:
- Replace any o-rings used
- Replace any connectors and filter housings with proper replacement parts
- Sanitize your system as often as needed (this changes with the profile of your area’s incoming water)
- Always use proper replacement filter cartridges with the correct size and length replacements
- Replace any teflon tape used
Copyright © 2018 by Express Water Inc.
A ll rights reserved. No part of this publication may be reproduced, distributed, or transmitted in any form or by any
means, including photocopying, recording, or other electronic or mechanical methods, without the prior written
permission of the publisher, except in the case of brief quotations embodied in critical reviews and certain other
noncommercial uses permitted by copyright law.
Conditions