Express Water Commercial Reverse Osmosis System, Руководство по установке

Страница: 17 / 28

11
System Connections
You may have already completed some or all of these connections in previous steps. Make sure to remove
any plugs before installing Tubing. Use the provided Locking Clips to secure any Tubing connections.
A to B Connect the 3/8” tubing to the Feed Water Adapter Valve (point A), remove plug then connect to the
open inlet of the branch tee on the sediment filter (point B).
To connect tubing to the Feed Water Adapter Valve, first remove the Lock Nut by unscrewing it
from the valve. You will then push the tubing over the ridge on the end of the valve. Then the lock
nut will go through the other end of the tube until you can screw it back onto the valve.
Drain
The drain line is this piece
coming off of the Membrane
Housing at the back of the
system.
Output
The outgoing flow line is
this elbow coming off of the
PAC. This delivers Pure Water
Outflow to your desired source.
Use the provided tubing
to direct your drain flow to
your desired location.
You can direct the drainage
into a drain saddle on a
sink pipe, into a floor drain,
or another option. that will
allow for unrestricted water
flow.
This can be connected to a
faucet or whatever else you
need to supply with your pure
RO water.
NOTE! If you are using a
tank, this is not where you
connect the tank
Drain
Line
A
B
Lock Nut
Pure
Water