Express Water Commercial Reverse Osmosis System, Руководство по установке

Страница: 12 / 28

6
Feed Water Adapter Valve
NOTE!
I f your Cold Water Valve is too old or weak to connect
to directly Option A you can connect at the top of the
line where the faucet connects Option B (if applicable,
some sinks do not have this connection point).
CAUTION!
The water supply to the unit MUST be from
the COLD WATER LINE. Using HOT WATER will
severely damage your RO System.
Do Not Connect To
Hot Water Line!
NOTE!
O n single-handle faucets the hot water may
have to be turned off to prevent hot water
crossover (only during your first installation).
If water still continues to come out of the faucet with
the Cold Water Valve turned off, then the main water
supply must be turned off as well.
2. Locate the Cold Water Valve underneath the sink
and turn it off completely. Next, open the cold water
handle on your sink to release pressure by expelling
any existing water. Check to make sure the water has
stopped flowing completely before proceeding.
1. First you will assemble the feed water adapter. Wrap
the threading of the smaller portion of the adapter
(with the red handle) with 10-14 wraps of teflon tape.
Then screw the smaller portion of the adapter into the
side of the larger portion as shown.
Hot Water Line
Cold Water Line
A
B
Teflon Tape