‘EXPOSED RACKS’ INSTALLATION GUIDE [8-00-9654-BK, 8-00-9754-BK, 8-00-9754-RD, 8-00-9656-BK, 8-00-9756-BK, 8-00-
9756-RD] FOR 2018 – PRESENT JL (2 dr) & JLU (4dr) JEEP WRANGLER WITH SOFT TOP
v.
2019M04D15V2
STEP 4 – INSTALL CROSSBARS (8-00-9905 hardware)
14)
3/8” Carriage Bolts slide though square bracket
holes, through the crossbar (bar not present in
picture to the right), then out the other side of the
square bracket hole, followed by Flat washer, Locker
Washer, then the 3/8” Nut. Tighten down fairly well
ensuring the lock washer compresses and the
bracket tab flexes and grips the crossbar. Crossbar
should have no movement once tightened.
15)
Install the 51” Crossbar (8-00-9651 or 8-00-9751) on the Front Brackets (8-00-9914)
16)
Install the 48 “ Crossbar (8-00-9652 or 8-00-9752) on the Mid Brackets (8-00-9911 or 8-00-9912)
The O’Land Crossbars come with a series of threaded holes on the bottom that allow for the weight distribution feet to
be used on the hard top (not used on soft top configuration here). These same holes allow user to mount just about
anything to the underside of the crossbar (e.g. light switch panel, CB Radio, etc.). Please see our website for updates
and kits available.
IMPORTANT: IT IS THE RESPONSIBILITY OF THE INSTALLER/USER TO DECIDE WHERE AND HOW MUCH WEIGHT TO
DISTRIBUTE IN ANY ONE LOCATION. IN THIS SETUP THE WEIGHT IS DISTRIBUTED DOWN THROUGH THE FRAME AND IS
FANTASTICALLY STRONG. THAT BEING SAID, WEIGHT CAPACITY IS LIMITED TO JEEP’S MAXIMUM STATIC AND DYNAMIC
WEIGHT LIMITS. WHEN PUTTING LOAD ON THE ROOF TOP, TAKE CAUTION TO ALWAYS DISTRIBUTE THE WEIGHT AS
MUCH AS POSSIBLE. USE COMMON SENSE WHEN INSTALLING AND CARRYING LOADS. EXR CROSSBARS ARE THE
