15
Cleaning the Brewing Components by Hand:
Cleaning the brewing surfaces on the lever machines is done as follows:
Note: The cleaning of the brew head should be done while the machine is cold to avoid
burns.
1. First you must remove the shower screen on your machine. The shower screen is
located at the same place the portafilter installs into the machine. Using a flat head
screwdriver, wiggle the screen out. You will have to work a little on one side, then
the other side, to get the screen out. The screen and gasket will come out together.
2. Separate the screen from the gasket as the solution can damage plastic and rubber
parts.
Note: Remember what side of the gasket faces up.
3. Add two tablespoons of cleaner to a container filled halfway with hot water. Soak the
shower screen, shot baskets and portafilter head in the solution for about 10 minutes.
Take care not to soak the portafilter handle; as the solution may damage the plastic.
4. After cleaning thoroughly, rinse all parts with fresh clean water.
5. Reassemble in reverse order, and you’re ready to brew some delicious espresso.
12. Cleaning the Housing
Use a non abrasive cleaner and a soft cloth.
Do not forget to disconnect the machine from the electrical supply before cleaning.
