EX9132C-2-MTCP
Manual
www.expertdaq.com
EX9132C-2-MTCP • Manual Version 1.1 • 21.09.2015
Page 5
Convert the sensors’ statuses (the sensors are connected to the converter) into the TCP/IP package data and
send them out with the Ethernet Data Stream; or use the TCP/IP package data to activate/deactivate the
specified digital outputs.
Dynamic IP Configuration
Support DHCP client mode, simplifying network address configuration and management.
Dual LAN Speed
Support 10/100 Mbps Ethernet, auto-detected.
Server / Client Dual Modes
EX9132C-2-MTCP converter device can be configured as network server or network client. In the client mode, it
can be installed in network which is protected by NAT router or firewall without a real IP address.
Web-based Setup
Parameters setup is based on HTTP protocol by using standard browsers (IE and Netscape). No special software
would be required.
Built-in Security Control
Security protect by login password to prevent intruders.
Remote Update
Firmware can be updated directly via Ethernet network to keep up with latest network standards.
1.5
Product Specifications
CPU: ARM Cortex™-M3 32-bit processor, 50MHz
RAM: 64K Bytes SRAM
ROM: 256K Bytes Flash ROM
Ethernet
o
Port Type: RJ-45 Connector
o
Speed: 10 /100 M bps (Auto Detect)
o
Protocol:
HTTP, DHCP
Modbus-TCP Master to Modbus-RTU Slave
Modbus-TCP Master to Modbus-ASCII Slave
Modbus-RTU Master to Modbus-TCP Slave
Modbus-ASCII Master to Modbus-TCP Slave
o
Mode:
TCP Server∕TCP Client∕UDP Client / Virtual COM / Pairing
o
Setup:
HTTP Browser Setup (IE & Netscape)
o
Security:
Login Password
