EX9132C-2-MTCP
Manual
www.expertdaq.com
EX9132C-2-MTCP • Manual Version 1.1 • 21.09.2015
Page 21
3.8
Controller Updated
Press “Update” Button after finish the detailed parameter setting. The converter will save all parameters into internal
non-volatile memory and then reboot. It takes about 5 seconds to complete the whole process, and a new login page
will be presented.
You can re-login and check if all parameters have been correctly saved. If everything is ok, you can close the browser
now.
Note: If the domain of the converter is different from that of the computer running the browser, the login page won’t
appear unless the converter’s “Gateway Address” has been correctly set.
3.9
Factory Default Setting
If you forget the setup password or have incorrect settings making the converter inoperable, there are two ways to
reset the setting and the following procedures can be used to reset all settings to factory default:
Please turn on the power and then use any point tip to push “Reset” button for 5 seconds. The password will be reset to
the factory default as “empty”.
