Your high performance HeatWave support belt has
been designed to provide you with warmth and support
where and when you need it, whatever the weather.
Our unique heating system uses FabRoc
®
, a
revolutionary polymer that is extremely efficient in
generating heat from a low voltage power pack.
FabRoc
®
panels are sewn into the garment to
provide direct heat to your body in certain key areas.
FabRoc
®
is scientifically proven to be therapeutically
beneficial, with no wires or hotspots, it transfers
warmth through your body via the bloodstream.
The FabRoc
®
panels are pre-set to a maximum surface
temperature of 50
0
C. It is not possible to ‘overheat’
FabRoc
®
as it automatically uses less power as it
reaches its operating temperature, a unique property
that ensures the material is very safe.
The support belt also features polycarbonated strips
and vented elastic panels that provide flexible and
adjustable support where and when you need it most.
GETTING THE BEST RESULTS
The closer the FabRoc
®
panels are to your skin, the more
heat you will feel, so you can create your own microclimate
wearing only a fine pullover, t-shirt or blouse underneath.
The portable power pack will provide heat on the lower
back area for up to 3 hours of continuous use at full
power. Experience suggests that you will get the best
from your HeatWave by turning the battery up and down
as described below.
Normally you would switch your belt on a few minutes
before wearing it. You should then be able to turn the
temperature down once it’s reached a comfortable level,
as the heat generated from your muscles will be sufficient
to keep you warm.
If you are resting, or the ambient temperature drops and
you feel cold, you can then increase the power indicator
and modulate as required to maintain your ideal comfort
level.
The Heat Inside
®
www.exo2.co.uk
USING THE POWER PACK
Fully charge your power pack before initial use, this will
take approximately 3 hours.
1. Remove connected cable from pocket.
2. Insert the small 1.3mm DC plug into the power pack.
3. See label on power pack for user operating instructions.
CHARGING THE POWER PACK
1. Remove power pack from the belt.
2. Connect charger unit to power pack.
The red light on the front of the charger
will light up when the charger is
checking on the level of battery power.
Fully depleted power packs will take
approximately 3 hours to fully recharge.
The red light stays on continuously while the power pack
is being charged. The red light turns to green when fully
charged.
The charger supplied has been chosen specifically for the
power pack supplied. No other charger must be used.
