Exmark Navigator NAV20KC, Руководство оператора

Страница: 39 / 48

- 34 -
j) Tighten the 4 engine mounting bolts and 4 jackshaft mounting bolts.
Check alignment after tightening.
k) Re-install pump belt tension spring.
l) Swing fuel tank in and re-install tank mounting nuts.
m) Complete Pump Drive Pulley Alignment Section 5.2.13.
5.2.13 Pump Drive Pulley Alignment
Pump drive pulley alignment is necessary for any of the following conditions:
•
The engine mounting bolts have been loosened or the engine has been
moved or replaced.
•
The pump pulleys have been loosened, moved, or replaced.
•
The PTO pulley alignment (Section 5.2.11) has been performed.
a) Stop engine, wait for all moving parts to stop, and remove key.
b) Loosen set screws on the both pump pulleys.
c) Using a straight edge, align each pump pulley with the engine pulley by
sliding along the pump shaft. See Figure 19.
d) Re-tighten pulley set screws and recheck alignment.
5.2.14 Rear caster pivot bearings pre-load adjustment.
a) Remove dust cap from caster and tighten
nyloc nut until washers are flat. Back the
nyloc off 1/4 of a turn to properly set the
pre-load on the bearings.
Note: If disassembled, make sure the
spring washers are reinstalled as shown in
Figure 20
5.2.15 Hopper Door Adjustment:
Door Closing:
a) Loosen 6 door hinge nuts. See Figure 21.
b) Open door and place a 3/8” rubber strip or 3/8” diameter hose between the
hopper and hopper door. See Figure 20.
c) Close door and push tight against hopper.
d) Tighten hinge hardware. Open hopper door and remove rubber strip.
FIGURE 21
HOPPER DOOR ADJUSTMENT
FIGURE 20
CASTER ADJUSTMENT