Maintenance
g013942
Figure 20
1.
Dipstick
3.
Add
2.
Full
4.
If the oil level is low, wipe off the area around the
oil fill cap, remove cap and fill to the “FULL”
mark on the dipstick. Exmark 4-Cycle Premium
Engine Oil is recommended; refer to the Engine
Owner's manual for appropriate API rating and
viscosity.
Do Not
overfill.
Important:
Do Not operate the engine with the
oil level below the “LOW” (or “ADD”) mark on
the dipstick, or over the “FULL” mark.
Check the Mower Blade
Service Interval: Before each use or daily
Always mow with a sharp blade. A sharp blade cuts
cleanly and without tearing or shredding the grass
blade.
1.
Stop the engine and wait for all moving parts to
stop.
2.
Disconnect the wire from the spark plug
(Figure 9).
3.
Drain the gasoline from the fuel tank. Refer to
Emptying the Fuel Tank and Cleaning the
Fuel Filter
section.
4.
Remove the bagger from the machine. Tip the
machine backwards until the upper handle rests
on the ground and place a jack stand under the
machine.
CAUTION
Raising the mower for service or maintenance
relying solely on mechanical or hydraulic
jacks could be dangerous. The mechanical or
hydraulic jacks may not be enough support
or may malfunction allowing the unit to fall,
which could cause injury.
Do Not rely solely on mechanical or hydraulic
jacks for support. Use adequate jack stands
or equivalent support.
5.
Inspect the blades for sharpness and wear,
especially where the flat and the curved parts
meet (see Figure 21). Because sand and abrasive
material can wear away the metal that connects
the flat and curved parts of the blade, check
the blade before using the lawn mower. If you
notice a slot or wear (Figure 21B and Figure 21C),
replace the blade.
g011478
Figure 21
1.
Sail
3.
Wear
2.
Flat
4.
Slot
DANGER
A worn or damaged blade can break. A
piece of the blade could be thrown into the
operator’s or bystander’s area, resulting in
serious personal injury or death.
•
Inspect the blade periodically for wear or
damage.
•
Replace a worn or damaged blade.
23
Содержание exmark 30"
