Exlar Curtiss-Wright Tritex II Series, Инструкция по установке и обслуживанию

Страница: 61 / 78

Curtiss-Wright | TRITEX II AC 75 Rev. K PN61928 7/12/2022 60
AF Option, Absolute Feedback
The Tritex absolute feedback consists of a combination of the
standard hall feedback and a low power battery-backed multi-turn
counter. The counter will track the motor’s position, as long the battery
voltage is present.
Battery life information:
Battery Life is typically 2 years from time of product purchase.
Low battery voltage:
When the battery voltage gets below 3 V, a low battery condition will
be set. This condition is typically set to generate a warning status on the
Fault Enable tab of the System Setup page. The warning status can then
be assigned to one of the outputs. The battery voltage can be displayed
on the Diagnostic page while on-line with the actuator. When battery
voltage gets too low to maintain the count value the Homed Status will
be off on the subsequent power up, requiring the actuator to be re-
homed. A low or dead battery does not keep the system from running it
just means a Home is required.
Replacing the battery:
Remove AC power, then remove the wiring access cover, pull the
battery out of the clip, and unplug the harness from the two pin
connector. The replacement battery kit is Exlar P/N 54108. The T2BAT1
kit (Exlar P/N 42712) for Tritex AC actuators will work, but outer sleeve
on battery must be removed to fit well in clip.
High Voltage
is present, remove AC power before
attempting to replace the battery. Replacement battery
assembly is Exlar PN 54108 or 42712.
Replacement with any other battery will violate UL and CSA certification.
WARNING