Exit Supreme Round, Руководство пользователя

Страница: 16 / 92

16
Supreme
Trampolines
1
1
2
Socket
T-joint
2
7
7 7
7
5
5
5
6 6
6
6
3
4
4
7
7
7
5
7
plastic sleeve
Kunststoffhülse
plastic koker
manchon en plastique
leg extension (4)
Stütz-Verlängerungen (4)
pootverlengstuk (4)
Jambe d’extension (4)
make sure the two holes are aligned
sicherstellen, dass die beiden Löcher ausgerichtet sind
zorg ervoor dat de twee gaten zijn uitgelijnd
assurez-vous que les deux trous sont alignés
3
small end
T-joint
Socket
STEP 1
Lay one Top Tubes with Socket(1) and
one Top tube with T-joint(2) on the
ground in position as shown. Make
sure the Top tubes are turned so the
small holes(spring holes) are facing
the ground. Insert one end of Top
tube with T-joint(2) into the other Top
tube with socket(1) as shown.
STEP 2
The peak of the Leg Brace should
point toward the ground. Insert the
Leg Brace(3) into the Leg exten-
sion(4), secure with M6x50mm
Bolt(5) , M6 Nut(6) and M6 Wah-
ser(7).
Insert the leg into the Socket and T-
joint. then press down on both legs at
the same time and fully insert them
into the Socket and T-joint, secure
with M6x50mm Bolt(5), M6 Nut(6)
and M6 Washer(7)
Note: do not tighten the Nuts
Repeat steps1 and 2 to assemble the
remaining five leg sections
STEP 3
Note: This step requires two per-
sons.
During this step, you will connect the
six assembled leg sections with the
remaining six leg top tubes
Stand two leg sections and hold them
in the position as shown. Slide the
large end of one of the remaining Top
Tubes onto the small end of the indi-
cated Top Tube on one of the leg sec-
tions. Insert the small end of the Top
Tube into the indicated Top Tube with
T-joint on the other leg section. Re-
peat this step until all six leg sections
are connected. When this step is
completed, the frame will be fully as-
sembled and freestanding.