EXCISION PGM 280, Руководство по эксплуатации

Страница: 6 / 28

6
1 SAFETY
1.1 . Safety Rules

Never allow unqualified persons to
operate or interfere with the machine

It is important to develop personal safety
awareness. Observe all related safety
regulations and pay attention for
hazardous conditions. Discuss these
conditions with your supervisor.

You must use personal protective
equipment, like safety glasses, gloves,
safety work shoes.

Do not remove warning signs and/or
instruction plates off the machine.

Make sure that all machine controls are
set for the desired mode of operation,
whenever the setting of the machine
control is changed, run the machine in
slow mode to make sure it operates as
expected.

Never disable any safety device to avoid
its assigned function. These devices are
intended to protect both the machine and
its operator.

Do not load, unload, operate or adjust the
machine without proper instructions.

This machine is specifically designed for
cutting general metal material. Do not cut
wood and analogous material, meat,
fishery, food and agriculture products,
combustible and radioactive materials.

Enough space should be provided around
the machine to avoid hitting and provide a
convenient operation.

Do not leave any tool on the machine after
use. Do not put work stock or tools
around the machine, to avoid injury.

Do not operate the machine with its safety
guards removed.

Do not wear gloves when operating
through control panel.

Wear gloves only when
loading/unloading the material, changing
the blade and chip brush.

Never touch the blade, moving work stock,
nor put your hands into the vise area or
chip conveyor unit until the machine halts
completely.

When selecting blade, blade speed and
coolant, please refer to the operation
manual or related documents.

Before installation and operate the
machine check the sufficiency of the earth
of the machine to your electrician. Do not
operate the machine without the earth.

Determined and declared bench life of the
machine by the Ministry of Industry and
Trade is 10 years.

For longevity please follow the
maintenance directions at the manual.
1.2 . Danger Zones on the Machine

Do not open the guards/covers during
operation.

During cutting process keep your
hands and fingers away from running
blade which should on number one.

During cutting process keep away
from zone number two. It may cause
hitting and dropping injury.

Do not Touch electrical panel if you
are not expert on electric
1
2