Page | 12
l
Connect the heater to a 230-240V~ 50-60Hz power outlet. Set the rocker switch
to the position II: The heater starts working.
Attention: Remote control cannot operate the heater at this stage.
l
Connect the heater to a 230-240V~ 50-60Hz power outlet. Set the rocker switch
to the position O: The heater power is off.
l
Connect the heater to a 230-240V~ 50-60Hz power outlet. Set the rocker switch
to the position I, the heater will begin in Standby mode, at this time the symbol “- -
“will be flashing to indicate the unit is in standby mode.
l
Press the KEY “ON” the remote control, the heater start will run at the high power
(P3);
Press the “LOW”, “MED” and “HIGH” on the remote control, the heater will work
at LOW, MED and HIGH power setting, and symbol “P1” “P2” “P3” will be indicated
on the display zone.
P1
：
33% of the rated power
P2
：
66% of the rated power
P3
：
100% of the rated power
l
TIMER FUNCTION.
l
THE heater comes with a programmable timer that will automatically place the
heater in Standby mode after 1, 2, 3, 4 … max. 13 hours of operation.
To activate the timer, point the remote control directly to the receiver and press the
button “1 hr” , “01” will be indicated on the display zone as shown below. This will
trigger the heater to automatically go into Standby mode after 1 hour of operation.
Once in Standby mode, the symbol “- - “ will be flashing.
（
LOW setting
）
（
HIGH setting
）
（
MED setting
）
