15
X-Cite® mini+ User Guide
035-00587R rev. 5
i.
Select “Color” and scroll up /down through the options until desired color is on
LCD.
ii.
Click dial to save selection and return to “LCD” menu.
e.
Select “Exit” to go back to the main menu, or press and hold dial to return to the home
screen.
4.3.3
Favo – Favorite Intensity Setting
In the FAVO sub menu, a favorite, commonly used intensity setting can be saved. When this
mode is enabled, the intensity level will instantly jump to this setting with a double-click of the
dial. A second double-click will toggle back to the previous intensity level.
a.
Select “Favo” option from main menu.
b.
To set/change the favorite intensity:
i.
Select “Int” and scroll through % intensity settings until the desired level is
reached.
ii.
Click dial to save selection and return to “Favo” menu.
iii.
TIP: Scrolling through % settings in this menu will not actually change the output
in real time, even if LED is on. The favorite intensity should be determined
before entering this menu.
c.
To enable/disable favorite intensity mode:
i.
Select “Enbl” and scroll up/down to the desired setting.
“On” will enable (i.e. double-click speedDIAL = Favorite setting)
“Off” will disable (i.e. double-click speedDIAL = do nothing)
ii.
Click dial to save selection and return to “Favo” menu.
d.
To adjust the delay between clicks in the “double-click”:
i.
Select “Spd” and scroll up/down to the desired delay setting. “1” will provide
the shortest delay, “10” will be the longest.
ii.
Click dial to save selection and return to “Favo” menu.
iii.
TIP: If double-clicking results in the light being turned OFF instead of going to
favorite intensity, increase the delay setting.
iv.
Note: Setting long delay times will result in a longer response time for regular
ON/OFF control with speedDIAL (the system must wait to see if the single-click
turns into a double-click). Response times for TTL, USB or foot pedal on/off
control will not be affected.
4.3.4
TTL –TTL Mode Control
In the TTL menu, TTL mode can be enabled for experiments that require rapid LED ON/OFF
control. For further information on TTL mode, refer to the External Control, TTL section 5.2.
NOTE: TTL mode MUST be enabled for the system to respond to a TTL signal.
a.
Select “TTL” option from main menu.
b.
To enable/disable TTL mode:
i.
Select the “Enbl” menu item.
ii.
Scroll to the desired setting, “On” to enable TTL or “Off” to disable TTL.
