E X C E L D R Y E R , I N C 1 . 4 1 3 . 5 2 5 . 4 5 3 1 1 . 8 0 0 . 2 5 5 . 9 2 3 5 ( U S / C N ) E X C E L D R Y E R . C O M
A D M I N @ E X C E L D R Y E R . C O M 3 5 7 C H E S T N U T S T R E E T, E A S T L O N G M E A D O W, M A 0 1 0 2 8
5 / 2 0 2 0
4
R E A D A N D S AV E T H E S E I N S T R U C T I O N S
5. Similar to step 4, align the slots on the hose
connector with the dryer output tabs. Insert Hose
Connector until it stops, then rotate clockwise
about 1/8th of a turn to snap into place in
direction shown (Figure 5).
NOTE:
Do not over twist, only needs 1/8 turn to lock into
place. Align hose connector tabs with the slots
on the dryer air outlet.
6. Connect the spout optic wire to the dryer box.
Simply align the male and female connector
halves via the (4) pins and then tighten via the
harnesses/connectors threaded section. Neatly
route wire so that it does not dangle under the
sink. Neatly route the power cord. Once all
work is completed, plug power cord into outlet to
check for proper operation (Figure 6).
NOTE:
Gently rotate the cable connector until it
engages with mating connector. Then tighten the
Knurled Nut.
Do not pull down on sensor cable, this may
cause damage to the unit.
Figure 5
Figure 6
Twist hose
connector
clockwise
