E X C E L D R Y E R , I N C 1 . 4 1 3 . 5 2 5 . 4 5 3 1 1 . 8 0 0 . 2 5 5 . 9 2 3 5 ( U S / C N ) E X C E L D R Y E R . C O M
A D M I N @ E X C E L D R Y E R . C O M 3 5 7 C H E S T N U T S T R E E T, E A S T L O N G M E A D O W, M A 0 1 0 2 8
5 / 2 0 2 0
2
R E A D A N D S AV E T H E S E I N S T R U C T I O N S
1. Remove the (3) nuts off of the threaded studs.
Attach the spout to the sink deck via the pre-
manufactured holes. Take care in positioning
the optic wire straight and near the front slot as
shown in Figure 1. Do not position optic wire in
front of the threads.
2. Attach the (3) nuts to the studs on the underside
of the sink deck to synch down the spout fixture.
Be sure when tightening front nut to move the
sensor cable out of the way so it is not damaged.
Proceed to tighten the nuts enough to securely
snug the fixture to the top of the deck without
over-tightening to a point that it could damage
the threads or sink deck. Double-check that the
optic wire is not pinched in-between the sink
deck and spout. The wire should sit in the cavity
on the plastic spout connector (Figure 2).
NOTE:
When tightening the front nut, be sure to move
the sensor cable out of the way so it is not
damaged.
CAUTION: Always make sure to have dryer electrical cord unplugged from outlet before performing any installation or maintenance tasks.
INSTALLATION INSTRUCTIONS
Figure 1
Figure 2
Optic Wire
Front Slot
Optic wire in slot.
