• Users Instructions
The Excalibur Xtra incorporates a high level control which links to a single gas control
,
which
selects ignition pilot
,
and main burner low and high settings. Also an aeration control behind the
ash pan cover on Nat gas model which works with a pull and push knob allowing the ad
j
ustment
of the flame picture.
The Excalibur Xtra incorporates
a safety device in the form of an Oxygen Depletion System,
which constantly
monitors the oxygen in the room and will cause the fire to switch off if the
oxygen level reduces, for instance due to insufficient ventilation or a blocked flue.
If th
i
s repeatedly occurs do not attempt to relight the appliance until a qualified engineer has
checked it, the problem may not be due to lack of air or a defective flue.
Warning:-This
appliance has a naked flame, has with all such fires it is recommended
that a
fireguard should be used for the protection of children, the elderly and infirm. Fireguards should
conform to BS 6539 (1984) (Fireguards for use with solid fuel appliances).
SECTION TWO •• - ..
The full lighting procedure is as follows
:
-
a
.
Push slide control lever down
,
as far as possible a clicking noise will be heard and
the pilot will light
,
HOLD DOWN FIRMLY FOR ABOUT 20 SECONDS.
b.
Allow the lever to spring up the pilot light should remain alight and the main burner
should light on its low setting.
c.
Should the pilot fail to light, pull the lever fully up to turn off the appliance, wait 3
minutes and repeat the procedure (a &b). If the pilot does not light and no clicking
noise is heard replace the battery and try again.
d
.
After lighting the pilot flame and the main burner on its low setting the control lever
may be lifted until slight resistance is felt, this will put the burner on its high setting.
e.
To completely extinguish the fire, pull the lever up past the resistance to its fullest
extent
.
f.
The fire may be operated on either its low or high setting.
g
.
It is recommended
that the appliance is operated on its high setting for a short
period before adjusting to the low setting.
h
.
BEFORE REQUESTING
HELP SHOULD THE FIRE FAIL TO LIGHT, ENSURE A
NEW BATTERY IS FITTED
Note: If the ignition does not operate fit a new 9V battery (PP3/MN1602)
to the ignition unit
,
located behind the fret adjacent to the gas inlet pipe, and repeat ignition procedure
prior to
reporting a fault
.
5790
1