installer Programmable Features (cont’d)
Feature #17 Low Temp crank Extender
0ms (Off)
(press “
start
” 1 time to program)
200ms
(press “
start
” 2 times to program)
- DEFAuLT
300ms
(press “
start
” 3 times to program)
400ms
(press “
start
” 4 times to program)
When the vehicle’s interior temperature is below freezing, this feature adds extra crank time to the
base timing (see installer feature #7). It applies to tachless modes only (installer feature #3)
Feature #20 Low current / motorcycle mode
On
(press “
start
” 1 time to program)
Off
(press “
start
” 2 times to program)
- DEFAuLT
This feature, when on, reduces the system’s current draw by as much as 40% to maximize the
vehicle’s battery life while the alarm is armed. It causes the starter interrupt output to only oper-
ate when the ignition is turned on and reduces the frequency of the “armed” flashing status light
significantly. This is ideal when the system is to be used on vehicles that have limited battery
capacity and/or may sit for extended periods without charging the battery.
Feature #18 - Arm, Disarm or Additional channels
Arm / Disarm
(press “
start
” 1 time to program)
- DEFAuLT
Arm / channel 5
(press “
start
” 2 times to program)
channel 4 / Disarm
(press “
start
” 3 times to program)
channel 4 / channel 5
(press “
start
” 4 times to program)
The system has outputs designed for arming and/or disarming a factory-equipped security system.
These wires may be used instead to provide further system outputs, which are remotely operated
by the controller or transmitter. These outputs are in addition to the 2nd channel and 3rd channel
outputs. As shown in the programming assignment, the arm, disarm, channel 4 and channel 5 are
programmable as various combinations. For example, if the disarm output is needed, but not the
arm output, then channel 4 may be made available for use.
Feature #19 - horn Relay Functions
horn Output
(press
“
start
” 1 time to program)
- DEFAuLT
ignition
(press “
start
” 2 times to program)
Trunk Release
(press “
start
” 3 times to program)
Pulse After Start
(press “
start
” 4 times to program)
The primary function of this second relay, is to operate the vehicle’s existing horn; either in
conjunction with the electronic siren, or in place of the siren. Using both the siren and the horn
creates an extremely effective security system. Optionally, if desired or needed, this relay can be
programmed for the other functions listed above.
This device complies with FCC Rules part 15. Operation is subject to the following
two conditions, (1) This device may not cause harmful interference and, (2) This
device must accept any interference that may be received, including interference
that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the
user’s authority to operate the equipment.
14
