Excalibur P95-2 Zero Clearance Direct Vent Gas Fireplace
25
Pin
INSTALLATION
Place embers on the burner tray.
DO NOT BLOCK BURNER HOLES
13) Test fire to ensure proper light off (make
sure flame flows smoothly from one end of
burner to the other). If there is any flame
hesitation, check that area for any blockage
of the burner ports.
14) Reverse steps 1-3 under Optional Brick
Panels on page 22.
10) Place the top of Log 309 on Log 308,
supported by the knot.
11) Fit Log 310 on the pin and then swing the
front end of the log to hit the first grate tab.
12) Place the embers on the front of the burner
tray.
309
308
311
310
306
Rear Log
309
Middle Right Log
307
Middle Left Log
310
Front Left Log
312
Front Bottom Log
308
Center Right Log
311
Center Left Log
Knot
9) Place the back of Log 309 against the
bracket on the top right side of the burner.
The picture below is a view from the back
of the burner.
Rest log against
bracket
8) Place the top of Log 307 across the notch
on Log 311.
Notch
311
307
306
309
