Excalibur AL-185X-EDPB, Руководство по эксплуатации

Страница: 5 / 25

5
Controller & Transmitter Functions (cont’d)
Channel 3: Press and hold the “TRUNK” & “ “ buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 3 •
OUTPUT
UPON RECEIVING CONFIRMATION FROM YOUR •
SYSTEM, THE CONTROLLER WILL SHOW THE CHAN-
NEL 3 ICON
(1-WAY TRANSMITTER: PRESS AND HOLD THE “||” & “|||”
BUTTONS FOR 3 SECONDS)
Channel 4: Press and hold the “LOCK” & “TRUNK” buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 4 •
OUTPUT
THERE IS NO 2-WAY CONFIRMATION FOR THIS •
FUNCTION
(1-WAY TRANSMITTER: PRESS AND HOLD THE LOCK &
“||” BUTTONS FOR 3 SECONDS)
The engine will run for the preset run time (see user feature #17).
Run Time extender • : Press the “ ” button one time during remote start to
restart the engine run timer The timer will restart at “0:00”
nOTe: This can only be used once per remote start cycle. The controller will also give you
“run time expiration” warning (2 chirps) 1 minute before the remote start cycle ends.
If you decide not to drive your vehicle, you can turn off the remote start using •
the same method to turn it on (Default = press “ ” twice in 5 seconds)
nOTe: if user feature #17 is programmed for 1 press, the 1st press = Run Time extender so
an additional press is required.
Upon entering the vehicle during remote start mode, turn the ignition key to •
the “ON/RUN” position ( nOT STaRT!! ). When you press the brake pedal, the
remote start will turn off allowing the ignition key to take over.
*
*
*
Channel 5: Press and hold the “UNLOCK” & “ “ buttons for 3
seconds
YOUR SYSTEM WILL ACTIVATE THE CHANNEL 5 •
OUTPUT
THERE IS NO 2-WAY CONFIRMATION FOR THIS •
FUNCTION
(1-WAY TRANSMITTER: PRESS AND HOLD THE UN-
LOCK & “|||” BUTTONS FOR 3 SECONDS)
*