MANUAL WIPER SYSTEMS
•
11
Exalto type 214303
4.5 Wipe/wash program
This wiper control has a built-in ‘smart’ wipe/wash program. The program is as shown below. By
keeping button 1 pressed for more than one second, the Wipe/wash program will be activated. After
the Wipe/wash program has ended, the wiper will return to the wipe setting that was previously
used.
5. Failure
5.1 Continuous fl ashing signal
A continuous fl ashing signal indicates that the 210342 does not receive one or both parking switch
signals or it is not possible to reach synchronism. This may occur if:
•
one or both parking switches are damaged or disconnected;
•
one or two wiper motors do not run (damaged or disconnected);
•
one or two wiper motors do not run in fast or slow speed;
•
wiper motors run at too much diff erent speeds and it is not possible to reach synchronism;
• 10-pin connector has been inserted after power supply and control works as with one speed
motor.
5.2 Reset function
With any failure it is important you fi rst perform a reset process to the control system:
•
turn power off to the wiper controller
•
remove the 10-pin connector from the back of the console
•
inspect that all terminals are located correctly and in position
•
make sure the motor is connected correctly to the console
• wait 30 seconds
• reconnect the 10-pin connector to the back of the console
• turn power on
• test operation of the wiper controller
•
if problems continues, check notes on section 5.1
6. Available models
•
214303 Wiper controller for 3 wiper, max 12mA;
3 seconds
4 seconds
3 seconds
Spray
Spray
Wipe
Wipe
