MANUAL WIPER SYSTEMS
10
4. Operation
4.1 Functions of the push butt ons
All push buttons have a double function as described in the chart (see paragraph 4.4).
4.2 ON/OFF switching
By pressing and releasing button 1 or 2, the wiper can be switched ON or OFF. By pressing button 1 a
fast blinking LED will indicate the new wiper selection as in following chart:
Mode
LED (
= on)
Signal
Both wipers ON
Fast blinking
Right wiper only
Fast blinking
Left wiper only
Fast blinking
Both wipers OFF
LED’s OFF
4.3 Increase speed - decrease speed - intermitt ent mode selection
The wiper motor starts in SLOW speed mode (the only possible continous mode if one speed-motor
is used). By pressing button 2, the motor will power to FAST SPEED.
By pressing button 3, you can step down through the speed modes:
- SLOW SPEED - 2 SEC. INTERMITTENT - 4 SEC. INTERMITTENT - 8 SEC. INTERMITTENT.
By pressing button 2 you can step up through the speed modes.
4.4 Signals mode
The three LED’s shows the controller operation setting. By pressing any button, the mode will
change. The LEDS will fl ash as many times as the delay times (in seconds) between the wiper
strokes (if 4 seconds is the delay times between the wiper strokes, the LED will fl ash 4 times) or the
LED’s will have a light fl ash (slowly when SLOW speed is selected and quickly when FAST speed is
selected).
Mode
LED (
= on)
Signal
FAST speed
Fast slight blink
SLOW speed
Slow slight blink
2 sec. delay
2 slow blink
4 sec. delay
4 slow blink
8 sec. delay
8 slow blink
OFF
LED’s OFF
Wipe/wash
Failure
Asymm.
Continuous flashing signal
