eXact PipeCut Infinity, Руководство по эксплуатации

Страница: 15 / 20

Operation English
14
Cutting result adjustment on Exact PipeCut Infinity
The cut is affected by many factors, for example the
size of the pipe, material, wall thickness, quality of
the pipe's surface, roundness, welded seams, blade
condition, feed rate, operator's experience.
For these reasons, the saw may move to left or right
causing unperfect cut (see FIGURE K).
Infinity is heavily guided by the chain attaching the
saw to the pipe. It is important to place the chain
correctly and parallel to the pipe centerline.
Rotating the saw around the pipe before cutting
helps to align the chain.
If the cutting result is still not square, blade
alignment can be adjusted.
Adjusting the alignment of the blade
CAUTION! Blade alignment adjustment is very
effective and can lead to blade and/or saw damage if
adjusted too much.
Before making the adjustment, note the bodyplate
alignment in case it is needed to return back to the
original setting.
Loosen the two screws securing the bodyplate
(FIGURE L). Turn the bodyplate to the required
direction and tighten the two screws. Make only small
adjustments at a time.
If the cutting line goes from right to left (FIGURE K/a),
turn the bodyplate clockwise (FIGURE N / 1).
If the cutting line goes from left to right (FIGURE K/b),
turn the bodyplate counterclockwise (FIGURE N / 2).
CAUTION! The adjustment indicator located in the
back of the adjustment plate does give the exact
measurement to adjust. The indicator shows only the
direction of adjustment and the category of magnitude.
FIGURE K
Saw has moved from right to left
Saw has moved from left to right
FIGURE L
FIGURE N
End of the cut / laser line
Start of the cut / marking
Start of the cut / marking
End of the cut / laser line