Ex Machina Soundworks PULSAR, Руководство пользователя

Страница: 9 / 18

SECTION 3: INITIAL SETUP
UNBOXING
Inside each box you should find:
● One Loudspeaker
● One 6 foot IEC cable
As the tweeter diaphragm in particular is quite delicate, please observe the following steps to
safely unpack your loudspeaker:
1. Begin by placing the box sideways with the widest side down.
2. Cut the tape from the bottom of the box.
3. Fold the bottom box flaps against the rest of the box, tucking the flap that is towards the floor
underneath the box.
4. Stand the speaker back up on the now open bottom of the box.
5. Lift the box away from the speaker and foam inside.
6. Remove the top foam insert to release the edge of the front foam insert protecting the drivers.
7. Carefully remove the front foam insert from the bottom insert.
8. PLEASE DO NOT TOUCH THE TWEETER! EVER! ​ ( ​ The GrapheneQ ​
™ ​
tweeter diaphragms
are very delicate and will break if struck or poked. Doing so will result in a replacement charge,
as it will not be covered under your warranty.
INITIAL SPEAKER PLACEMENT
Because of the outstanding off-axis coherence and wide sweet spot of our designs, Pulsar and
Quasar are both quite forgiving of relative room placement. For fully optimal performance,
however, we recommend the following:
1. While optimal speaker spacing and listening depth can vary based on the acoustics of your
room and your own listening preferences, we recommend starting with the standard “equilateral
triangle” approach. However, when adjusting toe-in, we actually suggest aligning your primary
listening position 15° off-axis from the direct tweeter angle on either side. This listening position
8