Page 7
eWON500™
The Transparent Gateway
ver 1.0
9/11/05
User Guide
The FINS Hostlink/FINS TCP gateway configuration
Hardware configuration
• Set up eWON™
dip switches
to
RS232 mode
(All switches
OFF
) -Refer to appendix for dipswitch explanations
• Connect the
serial cable
between your eWON500™ and the PLC (see page 15)
IO server configuration
• Go to the
FINS
IO server page:
Configuration
/
IO Server Config
/
FINS
/
Edit
• Set the
Server Port
and
FINS TCP server node
according to your device (let the
Routing Entry fields
empty)
• Set the
Baud Rate
,
Parity
,
Databits
,
Stop Bit(s)
,
HW Mode
and
Reply Timeout
with the required values
• Set
Serial FINS network
and
Serial FINS node
to 0 (The data entered in the
Gateway
part will be used instead)
PLC software configuration
• Check that the entered data match the one entered in the network configuration from CX-Programmer then
GoOnline
You are now connected to your PLC through your eWON500™
• Please refer to the Troubleshooting section from this document in case of an issue
