EWM SATURN MIG 200, Руководство по эксплуатации

Страница: 4 / 68

CONTENTS
Page
Contents/2
5 Description of M100 / M110 Controls ................................................................................... 5/1
5.1 Description M100 Control ................................................................................................. 5/1
5.1.1 Setting the Working Point .................................................................................... 5/1
5.1.2 Selection of Operating Modes ............................................................................. 5/2
5.1.3 Choke Tappings .................................................................................................. 5/2
5.2 V / A - Meter with Hold - Function M110 (Option) ............................................................ 5/2
5.2.1 Display actual values during and after welding.................................................... 5/2
5.3 Setting further welding parameters ................................................................................... 5/3
5.3.1 Wire burn-back .................................................................................................... 5/3
5.3.2 Gas after-flow time .............................................................................................. 5/3
5.3.3 Feeding in the wire .............................................................................................. 5/3
5.3.4 Creep start........................................................................................................... 5/4
5.4 Sequence of functions - operating modes ........................................................................ 5/5
5.4.1 Sequence of functions 2-step .............................................................................. 5/5
5.4.2 Sequence of functions 4-step .............................................................................. 5/6
5.4.3 Sequence of functions spot welding .................................................................... 5/7
5.4.4 Sequence of functions Interval ............................................................................ 5/8
6 Description of M201, M210 Controls .................................................................................... 6/1
6.1 Definition of MIG/MAG welding jobs................................................................................. 6/1
6.1.1 MIG/MAG- Welding Jobs and setting of the working point
(without option M210 / operating mode programme, one-knob operation).......... 6/2
6.1.2 MIG/MAG- Welding Jobs and setting of the working point
(without option M210 / operating mode manual, two-knob operation)................. 6/3
6.2 Selection of the operating mode 2-stroke, 4-stroke, Spot welding ................................... 6/3
6.3 Selection of the choke tapping ......................................................................................... 6/3
6.4 Signal lamps for error messages...................................................................................... 6/4
6.4.1 Error message too much/ too little welding power pre-selected .......................... 6/4
6.4.2 Error message “No programme available“ .......................................................... 6/4
6.4.2.1 Short-circuit when the machine is switched on .................................... 6/4
6.4.2.2 Short-circuit at the first welding operation ............................................ 6/4
6.4.2.3 Short-circuit in any welding operation (contact ignition) ....................... 6/4
6.5 Correcting the wire feed speed ........................................................................................ 6/5
6.5.1 Correcting the wire feed speed with remote control (Option) .............................. 6/5
6.5.2 Correcting the wire feed speed with remote control on the welding torch
(Option)................................................................................................................ 6/5