Design and function
MIG/MAG welding
099-005682-EW501
7.9.2022
31
• The contact pressure has to be adjusted separately for each side (wire inlet/outlet) at the feed roll ten-
sioner setting nuts depending on the welding consumable used. A table with the setting values can be
found on a sticker near the wire drive.
Figure 5-14
5.2.2.4 Spool brake setting
Figure 5-15
Item Symbol Description
0
1
Allen screw
Securing the wire spool retainer and adjustment of the spool brake
• Tighten the Allen screw (8 mm) in the clockwise direction to increase the braking effect.
Tighten the spool brake until the wire spool no longer turns when the wire feed motor stops but
without it jamming during operation!
5.2.3 Welding task selection
For selection of the welding task and for general operation see the relevant Control operating instructions.
