EWM inverter TIG 150 DC, Руководство по эксплуатации

Страница: 43 / 49

12 Instruction Manual for Power Cooler Air Blast
12/1
12.1 Description of Unit
The power cooler is used for recirculating and cooling welding torch coolant.
The cooling unit is fitted with an Air Blast heat exchanger, therefore the efficiency of the cooling unit
is affected directly by the ambient temperature. The lower the Ambient temperature, the cooler the
air passing through the heat exchanger, therefore the higher the cooling effect. The operating
pressure of the coolant is monitored by a pressure switch, in the case of pressure loss then the
operation of the torch button control signal will be unlimited.
The built in coolant recirculation pump is fitted with a protective current overload.
The supply voltage for this unit is fed internally from the welding power source.
Application Range
:
The power cooler, is only suitable for use in conjunction with the following welding machine
inverter
TIG 200 DC
powerSinus
12.2 Technical Data:
power
Cooler
Mains voltage 1x230V
Mains frequency 50/60Hz
Max. torch loading 200A bei 35% ED
Maximum cooling capacity 1800 W
Maximum coolant pressure 3,8 bar
Working temperature range
-10
°
C up to +40
°
C
Protection classification IP 23
Insulation classification H
Type of cooling Lüfter
Coolant contents 5 Liter
Coolant type Coolant KF23E - 10
Weight
(incl.
inverter
TIG 200 DC
powerSinus
without coolant)
39kg
Dimensions (LxBxH) 640 x 280 x 305mm
Dimensions (LxBxH)
incl.
inverter
TIG 200 DC
powerSinus
640 x 280 x 620mm
12.3 Operating elements front and rear views of
power
Cooler module
Fig 21:
Operating elements front and rear view of
power
cooler module with
inverter
TIG 200 DC
powerSinus