7
Ewbank, 38 Bluestem Road, Ipswich, Suffolk, IP3 9RR Tel. 01473 271 272
NOTE: The number references in the following section relate to the
Appliance Overview image on page 5
CLEANING FLOORS
• Make sure the machine is unplugged from the electrical outlet.
• Unscrew the steam cap (6) by turning anti-clockwise.
Please note the cap cannot be unscrewed when the unit is
pressurized.
• Using the measuring jug and funnel (2 & 3) fill the machine with up to 1500ml of
water. This should be sufficient to steam clean for approximately 35 minutes
• Once full, replace the safety cap (6) by turning clockwise and fasten tightly
• Attach the accessory or floor cleaning tool you require to the machine (see page
6)
• Now plug the machine into the electrical outlet and switch on. Two lights should
illuminate. The red light is a power indicator. The orange light indicates that the
machine is building steam pressure
• When the machine is first turned on this light will illuminate. The machine takes
up to 12 minutes to reach the correct pressure level depending on the amount &
temperature of water
• Once the orange light has gone out the machine is ready to use. The orange light
may come back on when the machine is in use. If this happens, release the safety
trigger and allow the steam pressure to build up once again. This should take no
longer than 40 seconds. If the safety trigger is pressed when the orange light is
on, hot water may come out of the machine
REFILLING THE WATER TANK
• Switch the machine off using the on/off button (15)
• Disconnect the power cable from the electrical outlet. Wait 5 minutes before
squeezing the safety trigger to make sure the machine is no longer under pressure
before unscrewing the safety cap. DO NOT unscrew the safety cap until the steam
has stopped
• Fill the water tank as necessary using the funnel provided. DO NOT exceed
1500ml of water before replacing the safety cap by turning clockwise. Fasten cap
tightly
• You are now ready to switch the machine on and resume steam cleaning
HOW TO USE THE HANDLE
• Press the button at the end of the nozzle in to attach the straight adaptor or the
extension tubes
• Squeeze the trigger on the handle for steam
• Lock the trigger for constant steam
OPERA
TIN
G INS
TR
UCTIONS
Содержание STEAM DYNAMO+ EW0018
Страница 13: ...13 Ewbank 38 Bluestem Road Ipswich Suffolk IP3 9RR Tel 01473 271 272 ...
Страница 14: ...14 ...
Страница 15: ...15 Ewbank 38 Bluestem Road Ipswich Suffolk IP3 9RR Tel 01473 271 272 ...