Issue 1.2 May 2020
EVSE Protocol Controller 2.0 (EPC 2.0) | Viridian EV
16
6.2 EPC TERMINAL ASSIGNMENT
ALL VERSIONS
COMMISSIONING
To test if the EVSE built with the EPC is functioning as intended it is suggested to initiate a charging session and
check the operation of the unit by following the sequence below:
•
With nothing connected check that EPC LED is flashing blue
•
Connect the connector to the vehicle
-
Check that EPC LED turns to solid blue
•
Start a charging session on the vehicle
-
Check that EPC LED turns green and chosen contactor is energised
•
Stop a charging session from within vehicle (Type 2) or by pressing the switch to remove the connector from
the vehicle (Type 1)
-
Check that EPC LED turns to solid blue and contactor is de
-
energized
•
Remove connector from vehicle
-
Check that EPC LED
is now flashing blue
