DEPOLOX® Pool E flow cell
4. Installation
31
EN
Fig. 14
Conductivity module SiDISens (LF)
A Sensor cable to conductivity sensor
B
SiDiSens LF module
C
CAN socket for connecting the total
chlorine membrane sensor
D CAN connection cable with plug
Overview of CAN connection
Fig. 15
Pool Management System
A CAN connection at SiDiSens LF module for
connection of Membrane sensor or termi-
nating resistor M12 of the module SiDi-
Sens LF
B
Securing screw, DFMe electronics module
C
CAN socket for connection of CAN connec-
tion cable of the DEPOLOX® Pool E flow cell
or DFMe electronics module
D CAN connection cable
E
CAN extension socket
F
CAN connection cable for SiDiSens conduc-
tivity module or membrane sensor
4.19.2 Replace standard cell body cover
(optional)
The pressurized version can be retrofitted with
the total chlorine membrane sensor TC3 CAN.
Please note that the standard cell body cover
must be replaced by an optional cell body
cover (W3T417269).
1 Unscrew the standard body cell cover.
2 Remove from the optional body cell cover
(E) the union bush (A) with dummy disc
(B) and O-ring (C). Keep the parts for sub-
sequent use (equipped without memb-
rane sensor for total chlorine).
3 Screw the optional body cell cover (E) into
the lid of the cell body (pressurized ver-
sion).
4 First install the gasket (W3T164773) and
than the clamping ring (W3T171789) in
the corresponding opening on the cell
body cover (D)
5 Install the sensor measuring module
DFMe for total chlorine TC3 CAN (chapter
4.19.1).
Fig. 16
Cell body cover (W3T417269)
A Union bush
B
Dummy disc
C
O-ring
D Opening for cell body cover
E
Cell body cover (W3T417269)
A
B
C
D
A
D C
E
B
F
C
A
B
D
E