EVOnet C-FB310DN, Руководство пользователя

Страница: 14 / 58

User’s Manual
8
 Network LED: Indicates network connection status. See Appendix – LED Indicators for details.
The LED will not light regardless of the status if the Status LED is disabled when configuring
the
System – General setup.
NOTES:
 Camera surveillance may be prohibited by laws that vary by region. Check the laws in your
area before using this product for surveillance purposes.

To make connections on the power connector strip, press and hold the button and insert the
wire in the hole below the button. After releasing the button, tug gently on the wire to make
certain it is connected. To disconnect a wire, press and hold the button above the wire and
pull out the wire.
CAUTIONS:
 The frame GND of the power should be grounded before using.
 The camera restarts after the power adaptor is disconnected from the camera
when switching the power source from 12 VDC to PoE.
 The network connector is not designed to be connected directly with cable or
wire intended for outdoor use.

It is required that you coil twice the end of the network cable in the camera side
by using the core (28A2024-0A2 model of Laird Technologies brand) provided
with the camera for EMI (electromagnetic interference) suppression.
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY
FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET. USE
THE POWER CORD THAT HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES
NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG. DO NOT
OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES INTO ONE CIRCUIT.
Installation
A lens is not supplied with the camera. Ask your dealer or distributor about purchasing one. The
camera supports manual iris and the DC-type auto-iris lenses, and it accepts CS- and C-mount lenses.
NOTES:
 A mega-pixel lens is recommended for the best image resolution.
 Video-type auto-iris lenses are not supported.
 Use a lens that weighs less than 1.0 lbs. (450g). If the lens weighs too much, the camera might
become unstable.
WARNING: You might need to reinforce the wall or ceiling. If the wall or ceiling is not
strong enough to support the camera, the camera might fall damaging the camera
or causing injuries.