Evolution Dog wash, Руководство пользователя

Страница: 42 / 60

Evolution Dog Wash Owners/Operators Manual Page 42
As with any piece of equipment, the maintenance to the EVOLUTION is the key to its longevity. Ensure
that the person(s) performing the maintenance understands the steps and tools needed to perform the
maintenance. The following is a list of suggested maintenance items. If an operational problem occurs
it should be addressed immediately to prevent downtime or possible damage to the EVOLUTION. You
will develop your own procedures based on your business model.
7.1 Cleaning Procedures
Suitable clothing, hand and eye protection should be used prior to any cleaning procedure.
1. Use the operator switch to turn the EVOLUTION on, select the rinse option on the rotary dial
and wash the tub area of the dog wash using the dog washing gun, rinse all the excess waste
to the edges and under the floor and turn off gun.
2. Using the lifting tool, lift the floor and support using the support rod under the floor.
3. Carefully gather all of the waste hair prior to removing the square hair guard and properly
dispose of, do not dispose of into a waste drain.
4. Remove the square hair filter in the middle of the floor, clean any large remaining waste and
properly dispose.
5. Turn the wash gun on and rinse the tub area again, pushing the waste towards and into the
center filter/drain, while doing so wash the bottom side of the floor.
6. Remove the cylindrical filter from the drain in the middle of the floor. Do this by lifting out
the basket using the lip to assist removal. Empty the contents into the trash, again not
disposing into the waste drain system. Do not attempt to wash anything while this basket is
removed. Replace basket and do any other washing that may be needed at this time.
7. Replace the square primary drain.
8. Turn the wash gun on and select the disinfect option on the menu, wash underneath the
floor and the complete wash tub area.
9. Lower the floor and wash the complete tub area with disinfectant.
10. Turn off gun and operator key and remove key.
11. Using a soft cloth, wipe over the meter front, menu, and dog wash area. Do Not use abrasive
solvents, powders or paste.
12. Clean the stainless steel by wiping down with a light oil spray such as WD-40. Use caution if
using any type of stainless steel polish and follow the grain of the panel being cleaned. Avoid
using cleaner on Decals or Plexiglass.
See Pictures at the end of this section for orientation.