Evolution BORA 2800, Оригинальное руководство пользователя

Страница: 18 / 72

18
www.evolutionpowertools.com
(9.19)
INSTALLING A CUTTER
Select a cutter suitable for the operation to be performed.
Check the cutter to ensure that it is sharp and is not damaged
in any way.
• Insert the pilot pin into the cutter ensuring that it slides
smoothly. (Fig.5)
• Raise the cutting head to its highest position.
• Check that the cutter securing set screws located in the
arbor are not protruding into the spindle bore. (Fig.6)
• Align the two flats on the cutter shaft with the grub screws
in the spindle.
• Start to tighten one of the grub screws and at the same time
slightly rotate the cutter backwards and forwards until the
grub screw is fully tightened. This will ensure that the grub
screw is located squarely onto the flat preventing the cutter
from becoming loose.
• Tighten the remaining grub screw.
(>9.12)
SETTING UP
WARNING:
Before using the machine ensure that you have read
the sections on the intended and prohibited of use of this machine.
This machine should only be used for hole boring/drilling whilst
attached to the work piece by the electromagnetic base.
WARNING:
This machine is intended for use at any position,
but only if the electromagnet is in full working order and has
sufficient hold on the work piece material.
The safety strap or chain should be attached in case of power
failure or machine malfunction.
The safety strap or chain should NOT be used as an alternative
to the magnet for clamping purposes.
Always ensure the strap or chain is correctly fitted and the
machine is secure BEFORE starting the machine.
(9.12<)
FIG. 5
FIG. 6
CUTTING ADVICE