evoheat ALLHT1170R134, Руководство по установке, Страница: 17 / 36

5.Installation
Turn on the machine with on the remote controller, and then immediately
check whether the water pump operates normally; if it is normal, observe the water
flow switch and the water pressure gauge of the water system: when the water flow
switch is in the ON state, the water pressure gauge shall show the water pressure of
about 0.2MPa.
After the water pump has operated for some time, the compressor will start. Judge
whether there is any abnormal sound in the unit during operation with the sense of
hearing; if there is any abnormal sound, immediately cut off the power and check the
unit; if there is no abnormal sound, continue the operation and then note whether
the pressure of the refrigerating system is normal.
Check whether the input power and the current of the unit are consistent with the
performance data list in the Manual; in case of incompliance, stop the unit for check.
Adjust the water supply valve in each room, so that the temperature of each room
meets the use requirements.
Observe whether the outlet water temperature is normal.
Parameters of the remote controller have been set in the factory, and the user shall
not adjust it without permission.
5.9.2 Trial Operation
14
6.Usage
Welcome
V1.0
v1.0
Loading......
Press the button to set the clock,
the timer on or timer off
Press this button to check button function
or system state.
Press this button to confirm current operation.
ON/OFF
Press this button to start up/shut off the unit,
cancel current operation or back to upper interface.
HELP
MODE
CLOCK
Button Name Function
6.1 Function of wire controller
Press this key to select the upward option or increase
the parameter value.
Press this key to select the downward option or
decrease the parameter value.
Up
Down
15