22
04-2017 5325 00
INITIAL START UP
When the appliance starts up for the first
time, a guided sequence will be displayed
with the preliminary settings (language, ap-
pliance name, etc.).
After the choices have been made, the hy-
draulic circuit is filled up (installation).
Upon start-up, the mains solenoid valve
is opened automatically until the hydraulic
circuit is filled up.
Please note: If there is a lack of water
during the installation cycle, the appli-
ance will stop and wait for the water.
If substantial water pockets form in the
hydraulic circuit, then the hydraulic cir-
cuit must be manually filled.
After the hydraulic circuit has been filled,
the appliance rotates the brewing unit to
correctly position it; the display shows the
following in sequence:
-The software version of the appliance and
the software version of the touchscreen.
-The heating cycle status of the heating
unit(s).
When the heating cycle has finished, the
beverages will be available.
FIRST SANITISATION
When the appliance has been installed, it is
necessary thoroughly disinfect the mixers,
instant beverage dispensing pipes and tank
(if fitted) to ensure that the dispensed prod
-
ucts are hygienic.
Do not under any circumstances use
jets of water when cleaning.
The sterilisation is performed using sterilis-
ing products.
Wash the mixers and add a few drops of
sterilising solution
Once the sterilisation has been performed,
rinse the mixers well to remove any residue
from the solution that has been used.
To supply water to the mixers, use the rinse
function from the "washes" menu.
The appliance is equipped with an
automatic wash system for the mixers
and its hydraulic circuits, in addition to
the brewing unit.
If the appliance is subject to idle periods
(weekends, etc.), even for a period of less
than two days, it is good practice to enable
the automatic washing functions (before
beginning to use the appliance).
