11
12
SIX-SIDED CALIBRATION
STARTUP & CALIBRATION
1
2
3
5
6
4
Place gimbal as
shown.
The indicator light
will flash 2 times
when successful.
Place gimbal as
shown. The
indicator light will
flash 3 times when
successful.
Place gimbal as
shown. The
indicator light will
flash 4 times when
successful.
Place gimbal as
shown. The
indicator light will
flash 5 times when
successful.
Place gimbal as
shown. The
indicator light will
flash 6 times when
successful.
Place gimbal as shown. The
indicator light will remain
solid for 5 seconds and
then the gimbal will
re-enter standby mode.
Calibration is now
complete.
STARTUP & CALIBRATION
STARTUP CALIBRATION
If you find during normal use that your camera’s pitch or roll angle begins to drift or deviate then you need
to first try restarting your gimbal. Simply power off your gimbal and set it down on a flat non-moving
surface. Power on your gimbal and wait 5 seconds for the startup calibration lights to stop flashing. The
Startup Calibration is now complete.
The calibration sequence can be initiated through the EVO desktop calibration tool or through the
gimbal controls.
1. Press the power button to
turn the gimbal on - wait 5
seconds for the startup
calibration to complete.
2. Hold the thumbstick in the up
position for 2 seconds until the
indicator light remains on.
3. Hold the thumbstick down for 2 seconds until
the indicator light flashes once intermittantly.
NOTE:
See Page 11 to continue calibration
Power Button
